Разные. Танцев с бубном много было. С 401 по 408 изменял все параметры по разному.Добиться более плавного хода получается, но проблему рывков не решает.То есть более плавно в углах режет, но все равно дергается.
да блин... 406 какое значение ставили?
и цифры то не от балды нужно ставить..
рывки изза того что на прямых участках он разгоняется а на прохождение угла стоит ограничение скорости...
вот из описания
10.112.X previous version, this speed is the reference angle of 90 degrees, the maximum permissible corner speed value, recommended value 500 mm / min.
After 10.114.X version, the reference speed is angle of 120 degrees, the maximum permissible corner speed value, recommended value 200 mm / min.
This larger the faster processing speed, the corner but poor accuracy, the smaller the set value of this speed, the slower angular velocity, but the accuracy is
better corner. pay attention :
G code G61 or G09 is set if indeed stop detection (In-position check), the controller will automatically canceled corner deceleration mechanism.
If required the corner deceleration, the parameters 406 and 408 can be set to a maximum value, the corner will turn at a higher speed, but a large set
provided Pr404 (3000 mm / min speed, can be enlarged to 50ms), with "deceleration" after the way to provide the necessary acceleration and
deceleration machine protection against institutions badly affected. If the processing program comprising a single rotary shaft or the secondary shaft,
make sure to set the parameters 601 to 620, in order to avoid excessive jitter machine, recommended value is 500.
можно вообще до 8000 задрать... станок вообще тормозить не будет... но и углы все скруглит
а так для этого специально есть выбор сглаживания... вводите разные настройки для разного уровня сглаживания и в программе выбираете нужный режим