не знаком лично с роландами,
поэтому гадать не стану, но вот нашел описание
ошибки.
[Emergency Stop Z AXIS error]
An emergency pause occurred because Z-axis descent failed to stop.
Resuming is not possible.
The spindle head may be locked while automatic Z control is set to "ON."
Switch the poweroff and back on, then check the position of the lock lever forthe spindle head. After checking, redo the operation fromthe beginning.
If this message continues to appear, contact your authorized Roland DG Corp. dealer. P. 40, "Starting and Quitting," p. 82, "The Position of the LockLever," and p. 108, " Examples of Settings for Cutting Parameters"
Roland EGX 350 emergency stop z axis error
[Emergency Stop Z AXIS error]
Аварийная остановка произошла потому, что Z-ось не удалось остановить.
Возобновление невозможно.
Шпиндель может быть заблокирован, пока автоматическогое управление оси Z имеет значение «ON».
Переключить power OFF и обратно на ON, а затем проверьте положение фиксирующего рычага шпинделя.
После проверки, повторить операцию с самого начала.
Если это сообщение продолжает появляться, обратитесь к дилеру Roland DG Corp. dealer.
P. 40, "Starting and Quitting,"
p. 82, "The Position of the LockLever,"
and p. 108, " Examples of Settings for Cutting Parameters"
Сообщение отредактировал MiG: 10 Июнь 2015 - 15:16